10,000VA (10kVA) on-line, double-conversion UPS system for critical server, network and telecommunications equipment
Installs in only 6 rack spaces (3U power module and 3U battery pack); maximum installed rack depth of 32.5 in
Full-time sine wave 200, 208, 220, 230, or 240V +/-2% output
Actively converts raw incoming AC power to DC, then re-converts output back to completely regulated, filtered AC output
Operates continuously without consuming battery power during brownouts to 156V and overvoltages to 276V
Highly efficient operation in optional economy mode setting, saving BTU heat output and energy costs
Standard 3-wire 208V hardwire input connection; NEMA L6-30R and L6-20R output receptacles
Detachable input-output PDU module with manual bypass switch enables hot-swap UPS replacement without disrupting power to connected equipment
Network-grade AC surge and noise suppression
Zero transfer time between AC and battery operation
Network management interfaces support communications via RS-232, contact-closure port and optional SNMPWEBCARD slot
Supports detailed monitoring of equipment load levels, self-test data and utility power conditions via network interfaces
Includes PowerAlert monitoring software and complete cabling
Emergency Power Off (EPO) interface
Front panel LEDs provide at-a-glance confirmation of line power status, battery power status, AC-to-DC conversion, DC-to-AC conversion, bypass mode and output power status
LED/LCD display panel rotates for better viewing in rackmount or tower configurations
Detailed LCD panel with scroll buttons provides detailed diagnostic test information at startup and during self tests, plus real-time data on input and output voltage, frequency (Hz), load percentage and battery charge level